The Sewell PoE Injector can save you money by using an existing Ethernet line to deliver data and power. The Sewell PoE Injector can easily connect any IEEE 802.3af-compliant device to a non-PoE LAN switch port. This PoE Injector can be used to connect a wireless access point, IP phone, network camera, or any IEEE 802.3af powered device to a LAN switch. Reduce Wiring Costs: With the Sewell PoE Injector you can dramatically reduce wiring costs by powering devices through your existing Ethernet line rather than running new AC power lines. To use this product all you need to do is connect the Sewell PoE Injector to the LAN switch port, and then use your existing Ethernet Cable to deliver DC power and data to your device. Protect Your Equipment: Now that you are running DC power to your networked equipment through the Cat5 cabling, you need to be sure that your devices are protected from power problems The Sewell PoE Injector is equipped with short circuit protection keeping your devices safe. This product is designed to protect your products from overloads over 450 mA and high voltages exceeding 52V. Output: DC Output Voltage:50. Load: Min. 0.0A Max. 1.0A. Regulation:Line/ Load plus or minus4 percentage. Ripple And Noise:0.5 Vp-p. Total Output Power:56W. Efficiency: 80% (typical) at Max. load, and 120VAC 60Hz. Hold-up Time:16mS min. 120VAC and max. load. O/P Voltage Protection:60V max. at switch on and off at any AC line Phase. Input: AC Input Voltage Range:90 to 264VAC. AC Input Voltage Rating:100 to 240VAC. AC Input Current:0.5A(RMS) max. for 90VAC, 0.35A(RMS) max. for 240VAC. Leakage Current:0.25mA max. @ 254VAC 60Hz. AC Input Frequency:47-63Hz. AC Inrush Current:15A(RMS) max. for 115VAC, 20A(RMS) max. for 230VAC. Technical Specifications: Standard: IEEE802.3/3u 10BASE-T/100BASE-TX. IEEE802.3af Power over Ethernet. Connector: DC out: Power pin: 4,5(V+), 7,8(V-). Network Cable: 10BASE-T: 2-pair UTP/STP Cat.3, 4,5 cable, EIA/TIA-568 100-ohm (100m). 100BASE-TX: 2-pair UTP/STP Cat.5 cable, EIA/TIA-568 100-ohm (100m). LED: System: power (green). Power Input: 100~240V, 50~60Hz, 0.25A. Operating Environment: 0 deg ~ 40 degC. Operating Humidity:90 percentage Humidity (non-condensing). Storage Temperature: -20 deg ~ 60 deg. Dimension: 123(L)*61(W)*40 (H) mm.
- Power over Ethernet injector. IEEE802.3af compliance.
- Remote power feeding. Short circuit protection.
- Mix Ethernet and power into RJ45 port.
- Deliver power up to 100 meters.
- Plug and Play.
- Model No: 608-SW-29532
The Fine Print
Offer is not eligible for our promo codes or other discounts.